Airsoft MOSQUITO (Open Beta 2) Screw kit

All of the screw needed to finish your MOSQUITO (Beta 2) gun. You can find to 3d print files for the gun here: https://www.printables.com/model/564524-mosquito-airsoft-kit-open-beta-2

This is the screws, springs and pins for the airsoft mosquito beta 2 gun. There is enough of everything to build the battery stock or battery barrel! And just in case you lose some of your screws there is a little bit of extras in a separate bag!

This does not come with a gearbox, Inner barrel, magazine, hop nub, or hop bucking. But here is some of the things that I bought to make it work.

Gearbox: https://www.evike.com/products/18300/

Inner Barrel: https://www.evike.com/products/75130/ (If you want to use the original outer barrel this 140mm inner barrel will fit but if you want one to fit with this suppressor outer barrel https://www.printables.com/model/615123-mosquito-beta-2-outer-barrel then buy the 150mm inner barrel) https://www.evike.com/products/75131/

Magazine: https://www.amazon.com/dp/B0BZ56F33Y?ref=ppx_pop_mob_ap_share&th=1

Hopup Nub: https://www.evike.com/products/60822/

Hop up Bucking: https://www.evike.com/products/40404/ (I used this one and it worked but you have to cut it down to size for it to work so you might want to find a different one but if you are ok with cutting it this one works fine.)

Battery: https://www.amazon.com/dp/B0BCFTRRTC?ref=ppx_pop_mob_ap_share&th=1